Scraping

[Scaroline]

What's the lowest/most likely to scrape part on the CT4V Blacking? Its my first time driving a low car so I'm not sure which entry ramps I can go through and which ones are too steep.

 

[Grainofsand]

The air guide under the car. Its hard to see because its a little further back from the lip, but that's the part that always scrapes first

 

[1Evil55]

It's all in the angles...

 

[LF4472]

I think it depends on if your car has CF1. On my 4BW, I have more concern for the carbon splitter than I do the airdams (which is opposite from my Z06 which tends to scrape the airdams at the end of my driveway).

 

[DonD]

I have the Atlanta Raceway IMSA special edition 4BW. There is a TX DOT drainage dip between our neighborhood and the busy two lane road. It was next to impossible to cross the dip w/o damaging the front of the splitter. And damaged it got. Finally gave up and cut the damaged section off about 12" either side of the centerline.

Even so, I have to barely move the car while crossing. Don