What's the lowest/most likely to scrape part on the CT4V Blacking? Its my first time driving a low car so I'm not sure which entry ramps I can go through and which ones are too steep.
I think it depends on if your car has CF1. On my 4BW, I have more concern for the carbon splitter than I do the airdams (which is opposite from my Z06 which tends to scrape the airdams at the end of my driveway).
I have the Atlanta Raceway IMSA special edition 4BW. There is a TX DOT drainage dip between our neighborhood and the busy two lane road. It was next to impossible to cross the dip w/o damaging the front of the splitter. And damaged it got. Finally gave up and cut the damaged section off about 12" either side of the centerline.
Even so, I have to barely move the car while crossing. Don
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.