Search results

https://www.usatoday.com/story/news/factcheck/2023/01/19/fact-check-false-claim-bill-mandates-kill-switch-cars-police-drunk-driving/11066287002/

Just because the language has gotten us in trouble in this thread... There is a MagPad (with puck) that is universal with pinch welds and works with floor jacks/lifts https://zl1addons.com/collections/ct5-ct5-v-jack-pads-lift-pads/products/premium-3-inch-pinch-weld-magpad?variant=27712440001...

Florida State Championships today down in Ft Myers. Great site at Buckingham Field. Used to run National ProSolo and Match Tour events there, but the locals complained about the 300 cars running Fri-Sun, so they changed the rules. It's no longer suitable for National events, but for Local/State...

To me the disconnect was with the version of the lift point guys were using. Originally, ZL1addons was offering the original and the stealth pad. After I sent them pics, videos and measurements showing the original point DOES NOT FIT, they pulled it off the website as compatible with CT5. The...

GM sells complete assembly. Ring, hat and hardware. You can reuse the hat if you want. And AFAIK, it’s the only way to get new hardware for the ring.

I’ll try if I can get it to run in accessory only mode if I have time this weekend.

No. Nothing will to be best of my knowledge. It’s a simple fuse now, not a relay like ZL1 and Z06.

Drive with your back seat folded down. And the windows open. The car is INSANELY loud from outside. I get comments all the time from people at events.

Me too. Thanks for clarifying.

And just to be sure... @poor-sha yours don't have 'Mg' stamped on them anywhere?

Wait...the tech bronze wheels are Mg?

2nd to last AutoX of the season down here in Orlando. One more points event on 11/18, then a fun event on 12/2. Same venue I have posted previously...The FIRM in central Florida. (Home) Ran the back half of the track today. Can't do that with an SCCA club since we mandate 50' from any fixed...

The Blipshift love for Blackwings continues. https://www.blipshift.com/products/straight-outta-detroit-ii Only avail until tonight (Sunday, 10/5) at midnight.

Bleeding the clutch is virtually never required under normal (and even spirited) use. The fluid simply doesn't get hot enough to present the same issue as boiled brake fluid. Saying you must replace fluid when it hit 2% is a made up number. What brand fluid? In what application? 90% of cars on...

I'm not a drag strip guy. My only experience with the tree is at ProSolo events. Perhaps @WONT TAP will tell us what settings/procedures they use to launch?

You don't bleed the clutch in an Alpha chassis car. The procedure is 100 clutch pumps with the engine not running to cycle fluid.

MY understanding of 'best drag' settings is Sport - Competitive Mode. Gives you 100% engine power, enables launch control (if you want it. I always found it to be slightly slow, but very consistent), and PTM 'disabled'. PTM is not desirable on a drag strip.

Learned this lesson the hard way with camber plates on my SS 1LE. Sure it made it uber easy to change camber track-side, but there was no easy way to adjust the toe as a result of the new camber.

This intake is immediately a 'no' for me. It's got a cutout on the top of the lid. The CT5 hood doesn't seal against the top of the lid the way the Camaro does, for example. Means you are sucking hot air from engine bay right into the intake.

@Terrance Sig get any splitters out this week?