You could install with the bumper cover on if the cover already had the slots cut, you need to raise the the car remove the wheel and partially remove the inner fender well. I found the slots in the factory carbon fiber cover had to be very slightly increased in size. I had to remove my bumper...
Dirkbg. The support has very little room to move because of the shape and location inside the bumper cover and the top support is bonded to bumper. By the way your info and photos were a great help in the installation of my dive wings.
I forgot that I also used the new bumper cover for a test fit and found some of the slots were slightly small. So when I cut the original bumper I made the slots slightly larger . The right side was very easy to install the driver side to took a little more effort. On the driver side my rear...
it required increasing the size of hole where the retaining clip goes. Some needed it and some didn’t. I used a small grinding attachment on a cordless Dremel and a file to square the inside edges. It should take a little effort to install the retaining clips.
I installed Tapout dive planes and splitter. Used the supports from new bumper cover and cut holes in the factory cover. the dive plane did require slight modifications but fit great.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.