Recent content by marcmac

19x10 et20, 19x11 et50, gloss black. Got them from Precision Forged Wheels.

New wheels and a stainless works catback inst

No I didn't get a photo of them. They look similar to stock but the trasition to get them on the motors were a breeze. Maybe if you message stainless works or tapout they can get you a picture of the springs. The set came with new springs and hardware to mount to the mufflers, and a wiring...

I just installed the Stainless Works catback Exhaust, the sound is loud and deep way louder than stock . They ship with new springs for the valve motors. Did not have to do a valve relearn. Im satisfied with the Exhaust.

ARH just released longtubes for the CT5-V Blackwing

There's a guy in my local chapter in the v-club who's had cats failed and replaced.

Perfect fit out of the box, simple swap, installed with the oem hardware. After it was painted the bodyshop had the old hood off and this installed in 20 minutes. No fitment issues at all. I didn't get heatshields, asked a few members who been running the hood for a while and they said it's...

5

Anderson composites hood paint matched and Installed. image hosting with clipboard upload

Houston Chapter V-Club Cruise through the Sam Houston National Forest in Southeast Texas.

I got a new engine installed in May, September I got a low oil message. Put a quart in and checked the dipstick. A month later got another message for low oil and did the same. Took in for a cel for a small issues and told them the new engine was consuming oil. They changed the oil and told me...

Engine 😒

Got a milage range of 370 on a fillup, during a road trip from Houston to New Orleans. 5BW manual transmission.

I have a manual, my routine and the way the IGLA is set is that the parking brake must be engaged, start the car up, let the chimes stop then enter the pin hear 2 beeps then it's ready to go, takes about 10 extra seconds. If my parking brake is not engaged before or during entering the pin the...