Recent content by JohnDeere506

Anyone in MI want this before it goes to the auction site?

I ordered the one step colder ngks, will put them in tomorrow. For giggles I put on a 2.4 and the car loves it so far, should be about 13 psi from 12psi with the 2.5. The car runs smooth, clean, no felt issues or torque disturbance. Will re run on the dyno after colder plugs installed to be sure...

Top pic you can see the slight damage in the bottom on the corner of the spoiler. The other Pic just shows how awesome the carbon pattern is on these. And, they bolt on through the trunk which gives me far more confidence than 3M taped types.... I'll sell either one, the corner damage or the new...

The new one is in bubble wrap, new, new. The one with the slight damage ill get a pic of tonight and post from my phone later on.

This is brand new in package. Im selling 2 spoilers. Cant imagine shipping will be cheap so prefer a local pickup in SE Michigan but I will ship it if needed but buyer pays. $1075 perfect condition in bubble wrap still. I also have another new one that was just installed with slight corner...

Yeah Id say you are likely correct, and what Ive read also. We didnt do that but Id like to try 2 steps colder and see if it even makes a difference. Ive seen some dyno charts from well known tuners that were posted online and you can clearly see the torque and HP drop of around 5-6k rpm with...

Long story short I did the 103mmTB, ported stock blower, and 2.3in pulley, no tune as many shops suggest. It ran good ish and had good blower whine, but it started pulling spark at 5-6k rpm. It was not smooth, could feel seat of the pants then on dyno could clearly hear it pull spark and lots of...

thanks Im going to list both the new in package Anderson spoiler as well as the slightly damaged one I already installed. hey mount super solid using the bolts through the trunk, I would go any other way.T

I have a slightly damaged Anderson carbon fiber spoiler Im looking to sell and had to go another route due to get something in time for Woodward here in MI. Where do you suggest to sell to actually reach people with CT5s? Im also selling a 2.3 griptech pulley. I can try posting on the local...

Any updates on any tire sizes that work for the rear for some drag radials? I agree, 2024 6 spd 5BW and 1st and 2nd gear useless unless you baby it. Be nice to know what size DRs I can put on my Apex 19s. Thanks!

My friends lift is not available right now, so Im wondering if I can swap a 5BW long corsa catback without the lift? How high do you need to get the car to remove all the stock system without cutting? Im not a fan of using 4 jack stands but I could put it on solid 2x12s just depends how high it...

Im wondering the same thing for my new 5BW and surprised no responses