ZL1 Add-ons Jack pads Installed on CT4

[1BadTundra]

I installed the front 2 over the weekend, and wanted to offer up the other 2 for someone that wants to add these.
The rear of the CT4 has a large jack point already and no good place to add these pads. I didn’t see a pinch weld point back on the rear half of the rockers.. So I installed the fronts, I trimmed the plastic underneath for a perfect fit. The front has questionable jack points, these will be well worth it.
If anyone wants the front 2, I’m in York PA. Either pick up, or pay for their ride…

 

[KratosBear]

Looks good! I just ordered my ZL1 pucks too. I have a CT5 BW. What did you use to cut the plastic?

 

[rubberduck]

Looks good! I just ordered my ZL1 pucks too. I have a CT5 BW. What did you use to cut the plastic?

You don’t need to cut the plastic with a 5BW using the stealth pads.

 

[KratosBear]

You don’t need to cut the plastic with a 5BW using the stealth pads.

Why not? I purchased the stealth ones. Does it just rest on top of the plastic?

 

[rubberduck]

Why not? O purchased the stealth ones. Does it just rest on top of the plastic?

The lift pad rests on the plastic (deflects slightly), but is not under load when the car is jacked up. The load is carried by the pinch weld.

 

[1BadTundra]

Looks good! I just ordered my ZL1 pucks too. I have a CT5 BW. What did you use to cut the plastic?

Dremal on low speed with the PVC saw blade wheel